Electrical Stations are an important structure in Dying Light 2. Players can activate them to power Metro Stations, boroughs, and street lights of certain areas in the game, especially during the night.
They can also influence the City Alignment as unlocking one can give either the Peacekeepers or the Survivors the advantage, while they provide the players the chance to use them as parkour spots during combat situations or while traveling.
Finding the Electrical Stations
According to Gameskinny, a total of four Electrical Stations are needed to be activated in Dying Light 2 - one in Old Villedor and three more in Central Loop.
The lone Electrical Station in Old Villedor is located at the southern portion of Houndfield, about 250 meters west from the Main Terminal. It was bordered by a large chemical field to the north and west.
READ ALSO: 'Dying Light 2 Stay Human' Weapons Guide: How to Craft, Upgrade Them
To access the chemical field before entering the station, players need to bring either UV Shrooms or Immunity Boosters that they can consume to increase their immunity.
UV Shrooms, according to GFinity, are bluish wild mushrooms that usually glow in the dark. They can eat them to restore the third of their Immunity.
They can also use them as crafting materials for the Immunity Boosters with Chamomile, another plant they can find in the wild.
As for the remaining Electrical Stations in the Central Loop, the first one is located at the northwestern part of Downtown, while the second one is at the Garrison about 115 meters south of the VNC Tower.
The third Electrical Station is located in the northeastern part of Saint Paul, about 250 meters from the Saint Paul Cathedral.
Upon entering these stations, they need to restart the generators inside by connecting the electrical cables to their corresponding cables.
After connecting all of the cables in their terminals, they will wait for the elevator to pick them up towards the control room. Once they are inside, they will press the switch to activate the generators and bring the power back into the station.
Activating the Houndfield Station
To activate the Houndfield Electrical Station, jump towards a hanging yellow cage. From there, they will jump again to the yellow ledges on the pillar.
They will climb up the pillar until they see a zip line. Using its cable, players shall zip themselves to the opposite side of the room. From there, they will navigate through the room to search for Cable 2.
Once they get the power cable, they need to hold it, then jump down to the trash bags below the basement. After landing in the basement, they will search for Terminal 2 to connect the cable.
Then, they will go to a room on the left from Terminal 2. Inside, they will see a ladder that they can use to climb up towards another room. From there, they will search for another set of stairs that they can climb towards another room above.
Once they enter the room, they will grab Cable 1 to open the grilled iron gate to exit the room. From there, they will see another zip line that they will use to zip themselves and jump down to Terminal 1.
Activating the Downtown Station
To activate another Electrical Station at Downtown, grab Cable 1 in the basement. Once they get a hold of it, they need to search Terminal 1 behind the machinery.
After connecting the first cable, they grab Cable 2, head out towards the balcony. From there, they will swing across a platform in the middle using a rope.
Upon landing on the platform, they will run towards a locked gate and unlock the gate to give them access to Terminal 2.
After connecting the second cable, they will head towards an elevator shaft and jump down towards a floor that has Cable 3. They shall grab it and climb up to connect it to Terminal 3.
Activating the Garrison Station
According to PC Invasion, players will notice a cable labeled as "A/B." This means that the cable can be connected to both Terminals A and B.
After getting the cable, they will connect it to Terminal A, just a few walks away from another terminal where the cable comes from.
Then, press the button to open the metal gate beside Terminal A and enter a room where Terminal B is located. They will return to Terminal A to remove the cable, then head back to Terminal B to reconnect it.
After that, they will look for passageways to reach Cable 1/C. After getting the cable, they will cross a gap to bring it to Terminal C. After connecting it, open another metal gate to enter a room that has Cable 2.
Once they have the cable, they will drop down to an area full of water below that has Terminal 2. After connecting the cable, they will look to their right until they find a ventilation shaft. They will take the shaft to exit themselves from the area and bring them to the basement.
Then, they will go back to Terminal C to disconnect the Cable 1/C, and go down below to search for Terminal 1 and connect the cable.
Activating the Saint Paul Station
To activate the Saint Paul Electrical Station, according to Powerpyx, they will jump down into the water as they enter the building. As they swim across the water, they will notice the Cable 1/A/B.
After getting the cable, they will swim up and to the left until they exit the water. Then, they will look for Terminal A to connect the cable and press the button to open a metal gate.
Upon entering the room, they will go down the stairs to dive into another underwater area. They will swim straight ahead, turn right, then turn right again until they see a locked gate.
Then, they will turn around to swim towards another room to see Cable 2. Once they get the cable, they will swim back to where they found Cable 1/A/B, then head back towards Terminal A to enter the room and locate Terminal 2.
After connecting the cable, they will go back to Terminal A to disconnect the cable, head right, then go up to enter a room with Terminal B.
After connecting the cable, they will press a button to unlock the metal gate, then they will enter another room and dive into the underwater again. They will swim straight ahead until they will saw a set of stairs on the other side. They will take the stairs to see Cable C.
After taking the cable, they will swim back down towards the locked gate and connect it to Terminal C beside it. Then, they will press the button to unlock the gate and swim towards Cable 3.
Once they have taken the cable, they will open the locked gate beside it and swim to the right until they enter the room beside Terminal B once again. From there, they will search for Terminal 3.
After connecting Cable 3 to the terminal, they will run back to Terminal B to disconnect the cable and swim back to where they found Cable 3.
They will swim from the metal gate towards Terminal 1 to connect the cable and press the switch to enter the control room.
READ ALSO: 'Dying Light 2 Stay Human' Adds Anti-Piracy Support Days before Launch
Reginan Kurt Ivan Abang
